Details
Quick Start Earpiece:
Step 1> Load battery into earpiece
Open plastic box and under the sponge will find the battery.
Open battery case of earpiece by lift protuberant part. Make sure cathode face to handle and anode opposite to handle. Then close battery case.
Note: After loaded battery, earpiece starts work and Do not load battery in wrong direction.
If load battery wrongly in earpiece, the battery case will broken or battery stuck inside earpiece.
Step 2> Wear Earpiece
1> Clean ear canal by cotton swab.
2> Load earpiece into ear canal horizontally for maximize signal reception. Handle is better in down position for easy take out.
3> Put earpiece into canal deeply until its invisible.
Please take out earpiece and unload battery if stop use it.
Quick Start Bluetooth Neckloop:
Step 1> Pair with mobile phone
A. Put Bluetooth neckloop in pairing mode
1) With the Bluetooth neckloop power off, press and hold Bluetooth switch for 6-10 seconds until indicator turn on and flash between blue and red.
2) If Bluetooth is switched on or indicator flashing, press and hold Bluetooth switch for 5 seconds to turn off Bluetooth, then repeat above step 1).
B. Put Mobile phone in pairing mode
1) Go to mobile phone panel, turn on Bluetooth function and search for new Bluetooth device.
2) Select T-Loop then press OK or YES.
3) Enter password 0000 and press OK.
* Once paired, indicator change from flashing to blue. Some mobile phone need to connect manually after paired.
Step 2> Wear the neckloop
Hang the neckloop around the neck.
Can also put neckloop in coat pocket or put on legs when you are site down to drive sensitive earpiece, sexecute magnet earpiece. At magnet earpiece, the loop must be at your neck.
Write Your Own Review
Static CMS block displayed as additional tab.
You can insert any content here (text or HTML), e.g. info about returns and refunds.